7. Do not apply excessive pressure. This will not
increase the power tool’s drilling performance.
Lower pressure extends the life of the insert tool.
7.2.3 Hammer drilling (B) 7
NOTE
Working at low temperatures: The hammering mech-
anism works only when the power tool has reached
a minimum operating temperature. Bring the tip of
the drill bit or chisel into contact with the workpiece
and allow the power tool to run under no load until
it reaches the minimum operating temperature. If ne-
cessary, repeat this procedure until the hammering
mechanism begins to operate.
1. Turn the function selector switch until it engages
in the “Hammer drilling” position. Do not operate
the function selector switch while the motor is
running.
2. Bring the side handle into the desired position
and check that it is fitted correctly and secured.
3. Plug the supply cord into the power outlet.
4. Position the power tool and drill bit at the point
where the hole is to be drilled.
5. Press the control switch slowly (drill at a low
speed until the drill bit centers itself in the hole).
6. Press the control switch fully to continue drilling
with full power.
7. Do not apply excessive pressure. This will not in-
crease the power tool’s hammering performance.
Lower pressure extends the life of the insert tool.
8. Reduce drilling speed shortly before breaking
through in order to avoid damage to the surface
at the rear side.
7.2.4 Chiseling
NOTE
The chisel can be adjusted to 12 different positions
(in 30° increments). This ensures that flat chisels and
shaped chisels can always be set to the optimum
working position.
7.2.4.1 Adjusting the chisel (C) 7
CAUTION
Do not operate the power tool when the selector
switch is set to “Chisel adjustment”.
1. Turn the function selector switch until it engages
in the “Chisel adjustment” position. Do not oper-
ate the function selector switch while the motor
is running.
2. Bring the side handle into the desired position
and check that it is fitted correctly and secured.
3. Rotate the chisel to the desired position.
7.2.4.2 Locking the chisel (D) 7
Turn the function selector switch until it engages in
the “Chiseling” position. Do not operate the function
selector switch while the motor is running.
7.2.4.3 Chiseling(D) 7
1. Plug the supply cord into the power outlet.
2. Position the tip of the chisel at the point where
chiseling is to begin.
3. Press the control switch fully.
8. Care and maintenance
CAUTION
Disconnect the supply cord plug from the power
outlet.
8.1 Care of insert tools
Clean off dirt and dust deposits adhering to the insert
tools and protect them from corrosion by wiping the
insert tools from time to time with an oil‐soaked rag.
8.2 Care of the power tool
The outer casing of the power tool is made from
impact‐resistant plastic. Sections of the grip are made
from a synthetic rubber material.
Never operate the power tool when the ventilation
slots are blocked. Clean the ventilation slots carefully
using a dry brush. Do not permit foreign objects to
enter the interior of the power tool. Clean the outside
of the power tool at regular intervals with a slightly
damp cloth. Do not use a spray, steam pressure
cleaning equipment or running water for cleaning.
This may negatively affect the electrical safety of the
power tool. Always keep the grip surfaces of the
power tool free from oil and grease. Do not use
cleaning agents which contain silicone.
en
27
Commentaires sur ces manuels