Hilti 2062051 Manuel d'utilisation et d'entretien

*2068470*2068470PD-EOperating instructions enMode d’emploi frManual de instrucciones esManual de instruções ptPrinted: 18.11.2013 | Doc-Nr: PUB /

unintentionally for a brief moment. This eyelid closurereflex, however, may be negatively affected by medicines,alcohol or drugs. Nevertheless, as wit

Front edgeThread on the underside of the tool (battery compartment)Rear edgeSpikeThe PDA 72 measuring extension is screwed into theunderside of the to

6.4.10 Calibrating the inclination sensorIn order to achieve greatest possible accuracy whenmaking inclination measurements, the inclination sensormus

7Operation7.1 Distance measurementNOTEGenerally speaking, the individual steps in all functionsare always assisted by the graphic symbols displayed.NO

diameter is subtracted, the result is the distance betweenthe top of the pipe and the ceiling.1. Press the “Measure” button (the laser beam willswitch

7.3.4 Measuring cylinder volumeEach step of the volume measurement operation is indi-cated graphically in the display. To measure the volumeof a cylin

7.5 Pythagoras functionsNOTEA reduced level of accuracy, much lower than the levelof accuracy of the tool itself, must generally be expectedwhen the i

4. Aim the range meter at the target.5. Press the “Measure” button.The second distance is measured and displayed inthe intermediate result line.6. Aim

3. Press the “Measure” button.The first distance and angle are measured andshown in the intermediate result line.The graphic display then automaticall

8. Aim the tool at the target for room height and pressthe “Measure” button to take the measurement. Theroom height is measured and displayed in the i

ఆ௻ ௼௹ ௺ ௽ ௾ ௿ ఀఇ ఈఅ ః ం ఁఄఉ1Printed: 18.11.2013 | Doc-Nr: PUB / 5151889 / 000 / 01

The Offset function automatically adds or subtracts apredefined value to or from all measurements. This valuecan be entered manually or measured.1. Se

8.4.3 Hilti calibration serviceWe recommend that the tool is checked by the Hilticalibration service at regular intervals in order to ver-ify its reli

For EC countries onlyDo not dispose of electrical appliances together with household waste.In observance of the European Directive on waste electrical

*2068470*2068470Hilti CorporationLI-9494 SchaanTel.: +423/234 21 11Fax: +423/234 29 65www.hilti.comHilti = registered trademark of Hilti Corp., Schaan

234657Printed: 18.11.2013 | Doc-Nr: PUB / 5151889 / 000 / 01

8Printed: 18.11.2013 | Doc-Nr: PUB / 5151889 / 000 / 01

ORIGINAL OPERATING INSTRUCTIONSPD‑E laser range meterIt is essential that the operating instructionsare read before the tool is operated for thefirst

Location of identification data on the toolThe type designation and serial number can be found onthe type identification plate on the tool. Make a not

2.9 Control panel“Measure” button Quick start (when the tool is switched off, press the button briefly toswitch it on).Begins distance measurement.Act

4 Technical dataRight of technical changes reserved.Power supply 2 x 1.5 V, type AAA batteriesBattery condition check Battery condition indicator with

5 Safety instructionsIn addition to the information relevant to safety givenin each of the sections of these operating instructions,the following poin